Cortex VEXnet Manuál s instrukcemi Strana 64

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 95
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 63
ROBOTC
Download ROBOTC User Firmware 1
©
2007 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems
Download ROBOTC User Firmware
You will need:
Your VEX Microcontroller
A computer with
ROBOTC for IFI
2.0 or later installed
A VEX Programming Kit (1 USB-to-Serial cable, 1 VEX Robot Interface (“telephone”) Cable,
1 VEX Programming Module)
In this lesson, you will learn how to connect your VEX Microcontroller to the PC and load
the ROBOTC User rmware onto it, allowing the robot to run ROBOTC programs.
1. Plug the Robot Interface (“telephone”) Cable and the USB-to-Serial cable into the
Programming Module.
1b. ConnectRobotInterfaceCable
toProgrammingModule
Plug the end of the RJ25 “telephone”
cable into the matching port on the
Programming Module.
1a. ConnectUSB-to-SerialCable
toProgrammingModule
Plug the 9-pin Serial end of
the USB-to-Serial Cable into
the matching port on the
Programming Module.
Setup
Zobrazit stránku 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 94 95

Komentáře k této Příručce

Žádné komentáře